NBK DATA CENTER

2 Nos of AVTRON 2500kW load bank was supplied and commissioned by Gulf Incon International for NBK data center Kuwait.

ADDRESS HOTEL

24 Nos of AVTRON LPH 100  was used to test 2400amps Busbar Riser testing on diiferent floors. Only small load 100KW load banks could used on this project due to space constraints. Gulf Incon supplied and installed a...

ANNUAL MAINTENANCE CONTRACT

Gulf Incon supplied 1650kva Combined load bank as a part of Annual Maintenance contract to test the Generators installed in the Data Center.

Bolt Tensioning

ETISALAT EXCHANGE

FROMENT Multiple load banks were used to test 1500kVA X 3 nos of Diesel Generators. All 3 load banks were controlled using a single sigma remote controller. Bigger load banks could not use becuase of logisitics issues.

ETISALAT DATA CENTRE

4800kW Data Hall was tested using 704 numbers of rack mounted load banks. Each unit is rated 7kW at 230V,50Hz. Manual change over panel was used to select the A and B power sources.

PETROLEUM INSTITUTE

1500kVA Combined Resistive -Reactive load bank supplied to Petroleum Institute for permanent installation. Unit was installed in the roof of the building. Load banks is controlled through remote panel inside the electri...

ADNOC BUILDING

3300kVA combined load bank was used to test the Caterpillar generator installed in ADNOC Building.

EQUINIX DATA CENTER IMPEZ

Gulf Incon Supplied , installed and operated 400 Nos of rack mounted load bank to test 2500kW capacity data hall. Units were installed in the floor and connected through a control panel supplied by GII. Rack mounted load...

KHAZNA DATA CENTRE DUBAI & ABU DHABI

Gulf Incon International supplied 2 Nos of 2750 kVA Combined Containerized FROMENT load banks on 20ft trailer fitted with cable Drums. Each unit was supplied and commisioned at both sites by Gulf Incon. Khazna Data centr...

GULF DATA HUB

20 X 70 kW Load bank used to test 1400 kW Data Hall

CITY WALK

Gulf Incon supplied 2 Nos of FROMENT load banks on hire for testing 1500kVA Generator in the basement. Horizontal air flow load banks were required since the testing was carried out in the basement.